OK what is the one thing people hate to work on on the Vm 68?

The Trigger

So I got rid of it 

It's done and works good to.

I was playing around with different setups like I do and made this I think it's funny yet kind of cool looking at the same time.

Well here it is this has been a huge learning experience for me . 

Here is what I came up with for the recocking.

I may make a cover for this later but the gun works pretty  good

Still under construction 3rd look

Well it's almost done! The only things left are a recocking knob and the testing it.

I had to do some more cutting to fix mistake I had made . Now I have cut 2" off the back of the gun. Here you can see how much that really is .

The body is not the only thing that I had to cut, as you can see here the bolt and hammer had to be cut down. The Bolt had to be do to that mistake I made. But works fine now.

2nd look

In a strange twist of faith I had to give back the PT Enforcer trigger frame but I got my hands on an old Spyder Compact trigger frame and it fits better take a look 

This frame fits better and is smaller and uses lone star type of grips Bonus

Since it was smaller I cut a little over 1/2" off the back

Here are the post I am having welded on I have used a little solder to hold them in place

1st look

Some of you may remember talking about this a little in the forum.

I took the trigger frame off the PT Enforcer and put it on a Vm.

As you can see I cut the trigger blocks off the body and I had to cut about half of the big chunk in the front off Other things I did Mag spring mod and since I cut off the place the main back screw would go I drilled out the side hole and put a roller blade wheel pin to hold the back plug in 

Right now I have the trigger frame screwed on but this is going to change I am going to weld posts to the body that will have screws at the ends so the frame will just slide on the posts and put the screw caps on 

******NOTE******